Crochet Pug (Pacifier) Holder
If you're looking for a cute and practical accessory for your little one, a crochet pug-shaped pacifier holder is just what you need! These adorable holders not only keep your baby's pacifier safe and clean but also add a touch of charm to their outfit. The pug design is sure to bring a smile to everyone's face and make it easy to locate the pacifier when needed. Handcrafted with love and attention to detail, these holders make a wonderful gift for new parents or a delightful addition to your baby's essentials. Embrace the convenience and cuteness with a crochet pug pacifier holder — a must-have for any stylish baby on the go!
Note: This will be crocheted onto the closed side of the pin(the side that does not open).
Materials:
Row 1: Attach yarn to bar with a sl st and ch 1, do 6 sc across. Turn(6).
Rows 2 — 7: Ch 1, sc across to end. Turn(6).
Row 8: Ch 1, skip 1 sc, sc in next 3 sc, skip 1 sc, sc in last sc. Turn(4).
Row 9 — 18: Ch 1, sc across to end. Turn(4).
Row 19: ch 1, skip 1 sc, sc in next sc, skip 1 sc, sc in lat sc. Turn(2).
Row 20 — 42: Note: You can add or subtract rows from this section to make it longer or shorter).
Ch 1, sc across to end, turn(2).
The next row makes the ties to hold the pacifier.
Row 43: *ch 21, turn and work back along the chains just made. Skipping 1st ch, sc in each ch(20) back to row 42.* sc once in top of row 42. Repeat from * to * one more time and end with a sl st in last st on row 42. Fasten off and weave in ends.
You can use it the way it is or sew on some appliques to change the look.